...

Kinetic Control is the newest version of the Pocket NC control software and user interface. It can be installed on any V2 series machine since the software is housed on a microSD card instead of the machine itself. To update an existing V2 machine to the new Kinetic Control software and UI follow the instructions below. If you have a V1 machine that connects over HDMI please contact service@pocketnc.com to discuss update options. 

Boot Up Kinetic Control

Now that your machine’s calibration data is backed up you can prepare the machine to boot up using the Kinetic Control software. 

NOTE: If your machine was purchased before September 1, 2019 or has a serial number of 1800 or lower, please refer to the appendix at the end of this guide.

...

The Kinetic Control software is now completely installed on your machine. From here we recommend heading over to our User Resources page to check out our Kinetic Control Software Overview. 

...