...
then you will want to reduce the feed rate for the remaining tool operations.
Preamble
The g-code program’s preamble comes at the start of the program. The g-code preamble sets up the machine. For instance the G20 or G21 command would be found in the preamble to instruct the machine to use inches or mm, respectively. The preamble must be included in the g-code program.
...
The methods described above are both conservative methods. There are ways to eliminate cuts that have already been performed by the machine in the tool operation where the error occurred. Caution must be observed to not remove machine setup information at the beginning of the tool operation. The description of this process is outside the scope of this tutorial.
| Iframe | ||||||
|---|---|---|---|---|---|---|
|