...
Below is an embedded version of the Penta Simulator with the Clamp - Complete.ngc file loaded. You can use this embedded version of the Penta Simulator to experiment with modifying the g-code program and removing completed tool operations.
Use the following parameters to properly position the Clamp part in the simulator.
Tool 6 Z offset = -3.3427
Tool 25 Z offset = -3.3427
G54 Work Offsets:
X = -1.1723
Y = 1.7449
Z = 0.9225
| Iframe | ||||||||
|---|---|---|---|---|---|---|---|---|
| src | https://sim.pocketnc.com/?post=517/1 | |||||||
| width | 100% | height | 1000||||||
| Iframe | ||||||||
|
See the image below on how to toggle the G Code Pane ON and OFF.
...
Conclusion
The methods described above are both conservative methods. There are ways to eliminate cuts that have already been performed by the machine in the tool operation where the error occurred. Caution must be observed to not remove machine setup information at the beginning of the tool operation. The description of this process is outside the scope of this tutorial.
...