/
Clearing G5x Offsets in Kinetic Control

Clearing G5x Offsets in Kinetic Control

Sometimes the machine might not go to the expected coordinate point. When this occurs, it is important to clear the G5x offsets to return the Work Coordinate System (WCS) origin back to machine’s center of rotation.

To clear the G5x offsets, navigate to the SETUP page.

Locate the Work Offsets section.

Click on the G5x offset dropdown.

Kinetic Control defaults to G54 offsets. Select the G5x offset that you are using, then click on CLEAR CURRENT SYSTEM. The G5x work offsets are now reset.

 

 

Related content

V2 Series Work Coordinate System Tutorial (Kinetic Control)
V2 Series Work Coordinate System Tutorial (Kinetic Control)
More like this
Restarting a G-Code Program After an Error
Restarting a G-Code Program After an Error
Read with this
Cannot Select Work Offsets in Kinetic Control
Cannot Select Work Offsets in Kinetic Control
More like this
V2 Series First Part Tutorial (Kinetic Control)
V2 Series First Part Tutorial (Kinetic Control)
Read with this
Kinetic Control Software Troubleshooting
Kinetic Control Software Troubleshooting
More like this
Setting Work Offsets in Kinetic Control - Pocket NC
Setting Work Offsets in Kinetic Control - Pocket NC
More like this